Assembly is serviced with quarter outer panel, quarter inner structure, wheelhouse, lock pillar and rocker outer & inner panels. Time is to cut through the quarter and back glass openings in the sail panel and to section in the rocker in the door opening. On 4 door vehicles, time is to section rocker in the rear door opening up to the center pillar. Time includes the use of inserts (but not fabrication).
SPECIAL NOTATION:
Glass, moldings, mounting studs or mounting flange may be damaged or broken during normal service procedures on some applications. MOTOR advises that these factors be considered before performing glass operations in the event unavoidable damage occurs. Time for the removal of old adhesive, clean and preparation of sealing surfaces (vehicle and/or glass) should be estimated after an on-the-spot evaluation.
INCLUDED:
• Adhesive application if required (all types)
• Back window & reveal moldings
• Bolt on extensions & fillers
• Bumper assembly R&I (if necessary)
• Carpet & insulation turn back
• Cutting & welding as necessary
• Door striker
• Fuel door
• Glass
• Grind, fill & smooth welded seams (up
to 150 grit sandpaper)
• Interior moldings
• Lamps
• Parcel shelf
• Quarter trim
• Rear package tray trim
• Rear seat
• Regulator
• Remove & replace caulking
• Seal strips & weatherstrips
• Sill plates
• Stationary glass R&I (unless noted)
• Tail lamp
• Trunk compartment trim
DOES NOT INCLUDE:
• Antenna
• Carpet & insulation R&I
• Door
• Exhaust system
• Fuel tank
• Headliner
• Luggage compartment trim
• Moldings
• Mud guard
• Rear suspension or axle
• Remove outer panel from replacement quarter assembly
• Roof fabric cover R&I or pull back
• Stripe tape, decals or overlays
Footnotes found in a chapter contain vehicle-specific information. The content of footnotes is in addition to, and takes precedence over, information in the Guide to Estimating pages for the operation indicated.
REV. 8/06